Dimensions; Installation Area; Removing The Transport Bolts - Bosch Nexxt DLX Manual Del Usuario

- Covers to be placed over the
holes for the transport bolts
(after removing them).
- Clamp for drain hose.
- Wrench for levelling.
- Elbow for attaching the drain
hose, e.g. to a sink.
Depending on the type of
connection, the following may also
be required:
- Y connector (can be obtained
from any hardware store) in
case there is only a cold water
connection available.
Any residual moisture inside the
drum is due to the final testing
which every washing machine
undergoes before leaving the
factory.
On the rear of the appliance:
- Power cord with plug.
C = cold water connection
H = hot water connection
Useful tools
The following tools are helpful:
- Flat head screwdriver.
- Closed wrench (1/2"/13mm).
- Bubble level.

Dimensions

a = 27.0 inches (686 mm)
b = 30.7 inches (780 mm)
c = 37.0 inches (940 mm)
d = 16.0 inches (407 mm)
Door opening angle 180°
Approx. weight = 220 lbs (100 kg)

Installation area

d
WARNING
Never ground the washer to
plastic plumbing lines, gas lines
or hot water pipes.
This appliance must be installed
on a solid floor and well leveled
due to the higher spins speeds
available. If installing the
machine on a wood floor over a
basement or on a second floor,
the floor may need to be
reinforced. Sound, vibration, and
risk of walking" will be affected
depending on the structure and
stability of the floor surface
where it is installed.
If the washing machine is to be
installed on a weak wood floor
consider the following:
Soft floor surfaces, such as
q
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the
room.
Screw a water resistant
q
wooden board (at least 3/4"
thick) to the floor.
Secure the feet of the washing
q
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).
Units are not designed to be
q
stacked.
Units are not designed for
q
under counter installation
Pedestal Mounting
If mounting the washer on the
Bosch pedestal (accessory
no. WTZ1295) follow the instruc
tions supplied with the pedestal.
i
Install pedestal prior to
removing transport bolts.
Closet
If installing the washer in a closet,
observe the minimum distances
according to the following table:
Minimum Installation Clearances
Sides
d
Top
Rear
Front
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom: 24 sq. in (155 sq. cm)
Removing the
transport bolts
CAUTION
All 4 transport bolts must be re
moved before using the ap
pliance for the first time and must
be retained for any future trans
port (e.g. when moving).
Release screws using the 1/2"
q
wrench provided until they can
be moved freely.
Closet
1/4" (6 mm)
12" (3O5 mm)
2.5" (64 mm)
1/4" (6 mm)
7