ZUMEX ESSENTIAL PRO Instrucciones De Montaje página 2

ELEVATION KIT ESSENTIAL PRO / VERSATILE PRO
ASSEMBLY INSTRUCTIONS
1
CHECK THAT YOU HAVE RECEIVED ALL THE MATERIAL
CORRECTLY:
1
COMPONENTES KIT ELEVACIÓN
1 LEGS (x4)
3
FIT THE ELEVATION KIT
1 There are four holes on the base of the machine marked in
where the legs go.
The legs are supplied with some screw-in studs that are
already fitted into the ends of the legs. We must fully insert
them into the holes (A) on the base and then screw the legs in
as far as they will go.
A
Zumex Group, S.A.
Zumex USA & Canada
2
INSTRUCTIONS
2 INSTRUCTIONS
Tel: +34 961 301 251 · Fax +34 961 301 255 · zumex@zumex.com · Zumex Service Tel: +34 960 800 999 ·
Tel: 1 305 591 0061 · zumexusa@zumex.com · Zumex Service Tel: 1-877-ZUMEX-TA (1 877 986 3982)
2
PLACE MACHINE IN ASSEMBLY POSITION
1 Protect this area to prevent damages to the machine.
2 Carefully place the machine on one of its sides,
previously protecting this area to prevent damage to
the machine.
This operation must be carried out between two people,
so that the base of the machine is in view, facilitating
the work process.
4
PUT THE MACHINE BACK INTO ITS WORKING POSITION
1 Carefully stand the machine back up again leaving it in its
working position.
NOTE: Once this operation has been carried out with all
four legs, these can be mounted and removed when
required without the screw-in studs coming out of their
housing.
www.zumex.com
06465:00