Control Panel; Charging The Internal Battery - Bahco BBL12-400 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
5. FEATURES
Plug
types
C PLUG

6. CONTROL PANEL

DIGITAL DISPLAY
When the clamps are connected to a
vehicle's battery, the digital display indicates
the battery's voltage. When not connected
to a battery, the digital display is used to
indicate the percent of charge of the jump
starter's internal battery. See Display
Messages for a complete list of messages.
NOTE: If the vehicle's battery voltage is
too low to detect, the display will remain
blank; the voltage will not display. A manual
start procedure is required to enable
the jump start function. See Section 8.2,
Starting a Battery with Low Voltage.
NOTE: During charging, the display will
go into sleep mode and will not display
any messages. To turn the display back
on, press any button.

7. CHARGING THE INTERNAL BATTERY

IMPORTANT! CHARGE IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE AND EVERY
3-6 MONTHS, TO KEEP THE INTERNAL
BATTERY FULLY CHARGED AND PROLONG
BATTERY LIFE.
7.1 To reduce the risk of electric shock,
unplug the unit's wall charger from the
outlet before attempting any maintenance
or cleaning. Simply turning off the controls
will not reduce this risk.
All manuals and user guides at all-guides.com
1
2
3
4
5
10
9
8
19 20
17 18
16
13
14
15
G PLUG
1. BBL12-400
2. Battery clamp adaptor
3. 100V~240V 50-60 Hz.
6
AC wall charger (multi-adaptor base)
7
4. 12V DC car charger
5. USB/Micro USB connector
6. 12V port adaptor
7. Case
8. Adaptor for G plug
9. Adaptor for C plug
10. Adaptor for I plug
11. 12V Input socket for recharging
12. Light
13. USB port
14. 12V DC port
11
15. Jump starter output socket
12
16. Jump Start button
17. Digital display
18. Charging LED indicator
19. 12V/USB/Language button
20. Light button
I PLUG
LED INDICATOR
• Green LED solid – The internal battery
is charging.
• Green LED flashing – Charging has
aborted.
• Green LED pulsing – The internal
battery is fully charged.
FUNCTION BUTTONS
7.2 When charging the internal battery, work
in a well ventilated area and do not restrict
the ventilation in any way.
7.3 CHECKING THE LEVEL OF THE
INTERNAL BATTERY
To check the internal battery's charge
level, make sure the unit is turned OFF,
then press the
digital display will show the battery's
• 5 •
LIGHT – Operates the LED light
12V/USB/LANGUAGE –
Enables the 12V DC port and the
USB port
Press button for 5 seconds to select
the language on the display:
EN-FR-ES-DE-SE
JUMP START – Enables the jump
start function
or
button. The

Publicidad

Tabla de contenido
loading

Tabla de contenido