Maintenance Instructions; Storage Instructions; Troubleshooting - Bahco BBL12-400 Manual Del Usuario

12V ON-BATTERY xxx% – The 12V port
is in use.
USB/12V OVER LOAD – The 12V/USB
port is overloaded.
BATTERY LOW-RECHARGE –
While using the 12V/USB, the battery
voltage has dropped. The 12V/USB power
will shut off after 10 minutes.
Messages during use of jump starter:
xx.xV – Clamps are connected to a car
battery, but jump start button was not
pressed.
CONNECT CLAMPS-BATTERY xxx% –
Unit is turned on, but does not detect
battery clamps.
WARNING-CLAMPS REVERSED
(alarm sounds) – The clamps are
connected backwards to a battery.
BATTERY LOW-RECHARGE – The jump
start button has been pressed, and the
internal battery is discharged (will beep).

10. MAINTENANCE INSTRUCTIONS

10.1 After use and before performing
maintenance, unplug and disconnect
the unit.
10.2 Use a dry cloth to wipe all battery
corrosion and other dirt or oil from the
battery clamps, cords, and the outer case.

11. STORAGE INSTRUCTIONS

11.1 Charge battery to full capacity before
storage.
11.2 Store this unit at temperatures between
20°C - ±40°C (4°F - ±104°F).
11.3 NEVER completely discharge the battery.

12. TROUBLESHOOTING

PROBLEM
When recharging the unit,
the display shows BATTERY
TOO HOT TO CHARGE
or
When jump starting, the
display shows BATTERY
TOO HOT.
When recharging the unit,
the display shows BATTERY
TOO COLD TO CHARGE.
Alarm is sounding and display
shows WARNING-CLAMPS
REVERSED.
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
When the internal temperature is too
warm, the unit will not recharge (or jump
start), to protect itself from damage.
The internal battery's temperature is too
low.
Connections are reversed.
TURN OFF USB/12V – Attempting to
jump start when 12V/USB function is
activated.
OFF – The jump start button has been
pressed twice.
BATTERY TOO HOT – The internal
temperature of the battery is too warm.
Allow battery to cool down before
attempting another jump start.
JUMP START READY-BATTERY COLD
REDUCED PERFORMANCE – The
temperature of the internal battery is too
low, which reduces cranking performance.
JUMP START READY – The jump start
button has been pressed, unit is correctly
connected to a car battery, and the unit is
ready for jump start.
10 – Maximum 10-second-down counter
for engine start.
BATTERY COOL DOWN xx SEC
REMAINING – Shows waiting time needed
before attempting another engine start.
10.3 Do not open the unit, as there are no
user-serviceable parts; any servicing
should be performed by qualified service
personnel.
11.4 Charge after each use.
11.5 Charge at least once every 3 to 6
months if not in frequent use, to prevent
over-discharge.
Disconnect unit. Move the unit to a
cooler, well-ventilated location and allow
it to cool down before attempting to
recharge (or jump start).
Disconnect unit. Move the unit to a
warmer, well-ventilated location and
allow it to warm up before attempting to
recharge.
Disconnect the unit and reverse the
clamps.
• 8 •
REASON/SOLUTION