Sony CDP-CE515 Manual De Instrucciones página 17

6
Press ENTER to select the track.
Last programmed Playing order
track
1 2 3
PROGRAM
DISC TRACK STEP
1 5 3
After one second
1 2 3
PROGRAM
DISC TRACK MIN
1 5 1 3 . 1 8
Total playing time
7
To program other discs or tracks, do the following:
To program
Other discs
Other tracks on the same disc
Other tracks on other discs
8
Press · to start Program Play.
To cancel Program Play
Press CONTINUE.
You can select a track directly using the number
buttons
Press the number button of the track in Step 5. To select a
track numbered over 10, use the >10 button (see page 13).
You can create your program while checking the disc
labels
While the disc tray is open, follow Steps 1 to 8 with
pressing the DISC SKIP button to check the disc labels. If
you close the disc tray before Step 8, the total playing
time appears in the display after a while.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
Note
The total playing time doesn't appear when:
—You have programmed a track whose number exceeds 20.
—The total playing time of the program exceeds 200 minutes.
4 5
2 5
A
8
CD1
Programmed tracks
4 5
2 5
A
8
SEC
CD1
Repeat Steps
2 through 4
5 and 6
2 through 6
Checking the track order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
track (the disc and track numbers) or the disc (the disc
number and "AL" indication) of each step in the
programmed order. After the last step in the program,
the display shows "END" and returns to the original
display. If you check the order after you start playing,
the display shows only the remaining steps.
Changing the track order
You can change your program before you start playing.
To
Erase a track
Erase the last track in the
program
Add tracks to the end of the
program
Change the whole program
completely
Playing CDs Playing CDs
You need to
Press CHECK until the track
you don't want appears in
the display, then press
CLEAR
Press CLEAR. Each time you
press the button, the last
track will be cleared.
Follow the programming
procedure
Hold down CLEAR until
"ALL CLEAR" appears in
the display. Create a new
program following the
programming procedure.
EN
17