Connecting Another Cd Player - Sony CDP-CE515 Manual De Instrucciones

Getting Started

Connecting Another CD Player

If you have a Sony CD player equipped with the
CONTROL A1 jack and the command mode of that
player can be set to CD 3, you can control that player as
the second player with this unit. After connecting this
unit and an amplifier, follow the procedure below.
Be sure to turn off the power of each player before
making this connection.
COMMAND
MODE
To 2ND CD IN
To audio output
To an AC outlet
: Signal flow
EN
6
To LINE OUT
CDP-CE515/C460Z
To S-LINK/
CONTROL A1
To an AC outlet
CDP-CX200, etc.
To CONTROL A1
To audio input
Amplifier
To an AC outlet
What cords will I need?
• Audio cord (1) (Use the cord supplied with the player to be
connected.)
• CONTROL A1 cord (1) (not supplied)
1
Connect the players with an audio cord (see also
"Hookups" on page 5).
CDP-CE515/C460Z
2ND
LINE
CD
IN OUT
L
R
2
Connect the players with a CONTROL A1 cord.
CDP-CE515/C460Z
S-LINK
CONTROL A1
For details on this connection, refer to the
supplementary "CONTROL-A1 Control System"
instructions.
3
Set the COMMAND MODE selector of each
player.
Set the COMMAND MODE selector of this player
to CD 1 or CD 2, and set that of the second player
to CD 3.
COMMAND
MODE
CD
1 2
For details on how to operate the second player,
see "Controlling Another CD Player" on page 18
and "Playing Alternately" on page 19.
CDP-CX200, etc.
LINE OUT
L
R
CDP-CX200, etc.
CONTROL A1
3