Cleaning And Service; Environmental Protection - Würth 0981 121 Manual Del Usuario

Important
In case of socket version it is not admissible to mount the device on a tripod
with an angle exceeding 90° if exposed to splash water!
Maximum mounting height may not be exceeded!
IP 54:

Cleaning and service

‰ Clean the lamp with hot water, or if necessary
with usual cleaning agent.
Do not use technical solvents, acetone, benzene,
carbon tetrachloride etc.
‰ Do not allow oils and greases to soak in for a
longer period of time.
‰ A damaged lead may only be exchanged
by the manufacturer or an authorized service
company.
Exchanging the lamp
Proceed as follows (see fig. I) when changing the
lamp. Assembly is done in reverse order.
Important
To maintain the IP rating, ensure that
the lamp is closed correctly after
completed lamp change!
6
Disclaimer
The information in these operating instructions can
be changed without prior notice. Würth does not
accept any liability for direct, indirect, accidentally
or other damages or consequential damages which
result from the usage or the application of the infor-
mation in these operating instructions.

Environmental protection

Do not dispose of the appliance
with domestic waste. Dispose of the
appliance only via an authorized
waste management company or
your municipal waste management
organisation. Adhere also to the
applicable regulations. In case of
doubt refer to your waste management organisation.
Recycle all packaging material in an environmentally
friendly manner. Batteries may not be disposed of
with domestic waste. Hand in used batteries at your
supplier or at a battery collecting point.
Technical changes reserved.
We accept no liability for printing errors.
Adolf Würth GmbH & Co. KG, Abt. PFB
Künzelsau: 08.2010