Installing The Ait Library; Connecting The Power Cable - Sony LIB-81 Manual De Instrucciones

Installing the AIT library

The library weighs about 13.5 kg (29.8 lb.) and has the
following dimensions. Before installing the library,
make sure that the surface on which you are placing it is
large and strong enough.
Also, set the library horizontally so that its front and
sides are inclined by no more than ±1 degree in any
direction.
Front
Side
With the ACY-RK81 rack mounting kit (sold
separately), the AIT library can be installed on an
EIA-standard, universal pitch 19-inch rack. Contact
your dealer for information about the rack mounting kit.
Note
Install the AIT library on a horizontal surface near an
AC power outlet. Also, leave a gap of about 150 mm
(5.9 in.) behind the rear of the unit to allow air to
circulate.
Front 430 mm (16.9 in.)
660 mm (26.0 in.)
12
Installing the AIT library / Connecting the Power Cable
Connecting the Power
Cable
1
Confirm that the power switch on the rear of the
AIT library is turned off (a is pressed).
43 mm
(1.75 in.)
(1U)
2
Connect one end of the power cable to the power
supply connector and the other end to the power
outlet.
Rear
150 mm
(5.9 in.)