Troubleshooting - Acson IM-WM1W-0704- Manual De Instalación

If any malfunction of the air conditioner unit is noted, immediately switch off the power supply to the unit.
Check the following fault conditions and causes for some simple troubleshooting tips.
Fault
1. The air conditioner unit does not operate.
2. The air flow is too low.
3. Discharge air flow has bad odour.
4. Condensation on the front air grille of the indoor unit.
5. Water flowing out from the air conditioner unit.
If the fault persists, please call your local dealer/serviceman.
All manuals and user guides at all-guides.com

TROUBLESHOOTING

- Power failure, or the fuse needs to be replaced.
- The power plug is disconnected.
- It is possible that your delay timer has been set incorrectly.
- If the fault persist after all these verifications, please
contact the air conditioner unit installer.
- The air filter is dirty.
- The doors or windows are open.
- The air suction and discharge are clogged.
- The regulated temperature is not high enough.
- Odours may be caused by cigarettes, smoke particles, perfume
etc. which might have adhered onto the coil.
- This is caused by air humidity after an extended period of
operation.
- The set temperature is too low, increase the temperature setting
and operate the unit at high fan speed.
- Switch off unit and call dealer.
1-10
Causes / Action