Asus WL-169gE Manual Del Usuario página 6

Configuring with the WLAN utility (Ad Hoc)
The WLAN card supports Ad Hoc mode which allows communication between
wireless stations without an AP.
1. Right-click the wireless connection icon
and.select.Wireless Settings.
3..Click.the.Survey.button.to.scan.for.the.Ad.
Hoc nodes. Select the node you want to
communicate with and press Connect.
5..Check.the.Status.page.to.see.the.association.
state. If connection is established, the box
shows "Connected - xx:xx:xx:xx:xx:xx".
Quick Start Guide
2..Click.the.Config button.to.set.the.WLAN.
Card.to.Ad Hoc connection mode, Set the
SSID to. that. of. the. target.Ad. Hoc. node, , .
then.select.a.Channel on which the Ad Hoc
nodes.are.to.communicate..
4..If. the. encryption. settings. of. your. WLAN.
Card.are.different.from.those.of.the.other.
Ad.Hoc.nodes,.you.are.prompted.to.make.
the encryption of the two nodes identical.
Click.Apply to.activate.the.settings.
6..Check. the. Connection. tab. to. see. the.
signal.strength..Click.OK to exit the utility.
ASUS WLAN Card
Set the