Troubleshooting; Service And Support - Bellman & Symfon BE1481 Manual Del Usuario

Troubleshooting

If Try this
Nothing happens when I press Check that the batteries are firmly connected.

the smoke alarm test button.
Replace the smoke alarm batteries. Only use AA

Energizer Lithium L91.
Check the age of the smoke alarm, see the "replace

by" label on the unit.
The smoke alarm beeps when Check the receiver batteries and connections.

I press the test button but the
Move the receiver closer to the smoke alarm to

Visit receiver is not responding.
make sure it's within radio range.
Check that the units are set to the same radio key,

see
The Visit receiver is activated for Check for fumes, steam, etc. from the kitchen or

no apparent reason. bathroom. Paint and other fumes can cause nui-
sance alarms.
Change the smoke alarm battery if the red Visit

LED on the receiver blinks every 400 s, see
pattern.
If the problem persists, there is probably another

Visit system nearby that triggers yours. Change the
radio key on all units, see
The smoke alarm beeps and Check for any sign of contamination such as

chirps for no apparent reason. cobwebs or dust. If necessary, clean the alarm, see
Cleaning your smoke
If the problem persists, the smoke alarm is defective

and needs to be replaced.
28
Changing the radio key.
Signal
Changing the radio
alarm.

Service and support

If the device appears to be damaged or doesn't function properly, follow the instruc-
tions in the user guide and this leaflet. If the product still doesn't function as intended,
contact your local hearing care professional for information on service and warranty.
Operating conditions
Operate the device in a dry environment within the temperature and humidity limits
stated in this leaflet. If the device gets wet or is exposed to moisture, it should no longer
be regarded as reliable and should therefore be
Cleaning
Use a soft, lint-free cloth. Avoid getting moisture in openings. Do not use household
cleaners, aerosol sprays, solvents, alcohol, ammonia or abrasives. This device does not
require sterilization.
Warranty conditions
Bellman & Symfon guarantees this product (excluding the battery) for two (2)
years from date of purchase against any defects that are due to faulty materials or
workmanship. This guarantee only applies to normal conditions of use and service,
and does not include damage resulting from accident, neglect, misuse, unauthorized
dismantling, or contamination howsoever caused. This guarantee excludes incidental
and consequential damage. Furthermore, the warranty does not cover Acts of God, such
as fire, flood, hurricanes and tornadoes. This warranty gives you specific legal rights and
you may also have other rights that vary with territory. Some countries or jurisdictions
do not allow the limitation or exclusion of incidental or consequential damages, or
key. limitations on how long an implied warranty lasts, so the above limitation may not
apply to you. This guarantee is in addition to your statutory rights as a consumer. The
above warranty may not be altered except in writing signed by both parties hereto.
Model, type and classification
The information is available at the back of the smoke alarm.
replaced.
EN
29