Dust/Chip Extraction - Bosch PCM 7 Manual Original

28 | English
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
Mounting to a Working Surface
(see figure A)
To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material from the ma-
chine and the accessories provided.
– Fasten the power tool with suitable screw
fasteners to the working surface. The holes
12 serve for this purpose.
Inserting the Batteries (see figure B)
– Open the battery compartment 29.
– Insert the batteries provided according to
the specified polarity.
– Close the battery compartment.

Dust/Chip Extraction

Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health. Touching or
breathing-in the dusts can cause allergic reac-
tions and/or lead to respiratory infections of the
user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials containing
asbestos may only be worked by specialists.
1 609 929 U75 | (10.11.09)
All manuals and user guides at all-guides.com
– Use dust extraction whenever possible.
– Provide for good ventilation of the working
– It is recommended to wear a P2 filter-class
Observe the relevant regulations in your country
for the materials to be worked.
The dust/chip extraction can be blocked by
dust, chips or workpiece fragments.
– Switch the machine off and pull the mains
– Wait until the saw blade has come to a com-
– Determine the cause of the blockage and cor-
Integrated Dust Extraction (see figure C)
– Mount the dust bag 18 onto the sawdust
During sawing, the dust bag must never come in-
to contact with the movable machine parts.
Always empty the dust bag in good time.
External Dust Extraction
For dust extraction, a vacuum hose (size
Ø 36 mm) can also be connected to the dust
ejector.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Changing the Tool (see figures D1
Use only saw blades whose maximum permitted
speed is higher than the no-load speed of the
power tool.
Use only saw blades that correspond with the
characteristic data given in these operation in-
structions and that are tested and marked in ac-
cordance with EN 847-1.
place.
respirator.
plug from the socket outlet.
plete stop.
rect it.
ejector 21.
Before any work on the machine itself, pull
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
D4)
–
Bosch Power Tools