Bosch PCM 7 Manual Original página 29

Removing the Saw Blade
– Bring the power tool into the working posi-
tion.
– Turn the Allen screw 30 with the Allen key 22
provided while at the same time pressing the
spindle lock 28 until it engages.
– Hold the spindle lock 28 pressed and un-
screw the Allen screw 30 in clockwise direc-
tion (left-hand thread!).
– Remove the clamping flange 31.
– Press lever 3 and swing back the retracting
blade guard 5 to the stop.
– Hold the retracting blade guard in this posi-
tion and remove the saw blade 17.
– Slowly guide the retracting blade guard
downward again.
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Press lever 3, swing back the retracting
blade guard 5 to the stop and hold it in this
position.
– Place the new saw blade onto the interior
clamping flange 32.
When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Slowly guide the retracting blade guard
downward again.
– Place on the clamping flange 31 and the Allen
screw 30. Press the spindle lock 28 until it
engages and tighten the Allen screw turning
in anticlockwise direction.
Bosch Power Tools
All manuals and user guides at all-guides.com
Operation
Transport Safety (see figure E)
The transport safety-lock 24 enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle 1 down a lit-
– Pull the transport safety-lock 24 completely
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– Tighten clamping lever 25 to lock the saw ta-
– Press lever 3 and at the same time, swing the
The tool arm is now securely locked for trans-
port.
Clamping the Workpiece (see figure F)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
– Press the workpiece firmly against the
– Insert the screw clamp 14 provided into one
– Loosen the wing bolt 33 and adapt the screw
– Firmly clamp the workpiece by turning the
Loosening the Workpiece
– To release the screw clamp, turn the thread-
Before any work on the machine itself, pull
the mains plug.
tle in order to relieve the transport safety-
lock 24.
outward.
ble 11.
tool arm by handle 1 toward the rear until the
transport safety-lock 24 can be pushed com-
pletely inward.
fence 6.
of the holes 27 intended for it.
clamp to the workpiece. Tighten the wing
bolt again.
threaded rod 34 in clockwise direction.
ed rod 34 in anticlockwise direction.
1 609 929 U75 | (10.11.09)
English | 29