Bosch PCM 7 Manual Original página 31

Position of the Operator (see figure K)
Do not stand in a line with the saw blade in
front of the machine. Always stand aside of
the saw blade. This protects your body
against possible kickback.
– Keep hands, fingers and arms away from the
rotating saw blade.
– Do not cross your arms when operating the
tool arm.
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Mitre/Bevel Angle
Horizontal Vertical
0° 0°
45° 0°
0° 45°
45° 45°
Minimal workpiece sizes
(= all workpieces that can be clamped left or
right from the saw blade with the supplied
screw clamp 14):
100 x 40 mm (length x width)
Cutting Off
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Adjust the requested horizontal and/or verti-
cal mitre/bevel angle.
– Switch on the machine.
– Press lever 3 and slowly guide the tool arm
downward by handle 1.
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Bosch Power Tools
All manuals and user guides at all-guides.com
Replacing the Insert Plate
The red insert plate 7 can become worn after
long use of the power tool.
Replace defective insert plates.
– Bring the power tool into the working posi-
– Unscrew screws 8 using a Phillips screwdriv-
– Insert the new insert plate and and screw all
Sawing Profile Strips
Height x Width
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
50 x 110 mm
37 x 110 mm
50 x 76 mm
37 x 76 mm
– Lying flat on the saw ta-
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Transport
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
– Remove all accessories that cannot be
– For lifting or transporting, hold the power
tion.
er and remove the old insert plate.
screws 8 in again.
ble
tion.
mounted firmly to the power tool.
tool by the recessed grips 13 on the side of
the saw table 11.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
1 609 929 U75 | (10.11.09)
English | 31