Rear Panel - M-Audio BX4BT Guia Del Usuario

Features

Rear Panel

1. Rear Port: The rear port enhances
the bass generated by the woofer,
increasing the
Make sure these ports are not
obstructed since this will adversely
affect bass response.
2. Bluetooth Button: Press this button
to disconnect a paired Bluetooth
device and enter pairing mode. See
Pairing a Bluetooth Device
more information.
3. RCA Inputs: Use the included audio
cable or other RCA cables (sold
separately) to
sound sources to these inputs.
4. 1/4" (6.35 mm) TRS Inputs: Use
1/4" (6.35 mm) audio cables (sold
separately) to
sound sources to these inputs.
5. 1/8" (3.5 mm) TS Output to
Passive Speaker: This is the audio
connection to the passive speaker.
Use the included 1/8" (3.5 mm) TS
interconnection cable to connect
the active speaker to the passive
speaker.
6. 1/8" (3.5 mm) TS Input from Active Speaker: Use the included 1/8" (3.5 mm) TS
interconnection cable to connect the active speaker to this passive speaker.
7. Active Speaker Position: Adjust this to set the position for the active speaker in the
stereo field. This allows you to choose to have the active speaker on either your left or
right depending on your preferences and where your connections are.
8. High EQ: Turn this knob to boost or cut the high-frequency equalization of the speakers.
9. Low EQ: Turn this knob to boost or cut the low-frequency equalization of the speakers.
10. Power Connector: Plug the included 2-prong IEC power cable here.
low frequencies.
for
connect external
connect external
1
2
3
4
5 8
7 9
Tip/Hot
Ring/Cold
Sleeve/Ground
TRS
Connector
1
6
Tip/Signal
Sleeve/Ground
TS
Connector
5