Hansgrohe Mondial 15110000 Manual Del Usuario página 7

Important! The fitting must be installed,
flushed and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the slide washer, washer and collar nut
over the hose and threaded base and tighten
the collar nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation val-
ves;
cold right - hot left.
6. Connect the hose with hose nut, taper sleeve,
disc and washer.
7. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal pres-
sures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Der Auslauf läßt sich ca. 45 cm aus dem Auslauffutter
herausziehen.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 3 bars
Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Test certificate:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
6
English
If the continuous water heater causes any problems
or there is not enough flow of water, the waterdimmer
(7a) located behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
8.1 diverter knob
8.2 pull rod
9
10
11
12
13
Special accessories
X
(
7 l/min 3 bars XXX = Colors
000 chrome plated
max. 10 bars
090 chrome plated/gold plated
810 satinox
16 bars
880 satin chrome
max. 80° C
65° C
WRAS
0209015
handle
flange
nut
cartridge cpl.
locking screw for handle
seal
aerator cpl. (10)
aerator gold plated
pop up rod
fixing set
spout cpl.
non return valve DW 10 (10)
hose 900 mm
fixing set for hose connection
special tool set 58085000
order as an extra)
®
15092XXX
96338000
94192XXX
94194000
92730000
96059000
95008000
13085000
94980990
92620XXX
94066XXX
94067000
95049000
96524XXX
96456000
96511000
96444000