Pentair 320 Serie Manual De Instrucciones página 21

6. Place the light installation tool (P/N 620057) over the front of the light.
Turn the tool and light clockwise (less than an .3175 cm (1/8th. turn), while
pushing inward, until you feel the stop point. This indicates the light is
properly seated, locked and the niche is completely sealed.
Note: If the light does not turn smoothly, pull the light slightly out and make
sure that it's seated properly and the niche is free of debris, then install the
light as described in step 6.
Rotate handle 1/8
turn clockwise to
install or counter-
clockwise 1/8 turn
to remove
Light installation
and remove tool
GloBrite
7. Before operating the GloBrite color light, fill the pool with water until the light
is completely submerged.
Note: The GloBrite color light should not be powered for more than 30
seconds if is not submersed in water.
8. Final check for proper GloBrite light operation: Switch on the main switch
or circuit breaker to the 12 VAC transformer and the switch that operates the
GloBrite light itself. The light should illuminate when the 12 VAC power is
applied. If not recheck the installation steps.
Align and insert tool pins with holes
in front of light
®
Color Light Installation/Removal Tool
GloBrite Color Changing LED Pool/Spa Light Installation and User's Guide
11