Pentair 320 Serie Manual De Instrucciones página 23

THE GLOBRITE
COMPLETE LIGHT ASSEMBLY MUST BE REPLACED.
The following removal and installation instructions describe how to remove and install the
GloBrite color light assembly.
IMPORTANT NOTICE: THE GLOBRITE LED LIGHT IS A NON-
SERVICEABLE LIGHT. THE COMPLETE LIGHT ASSEMBLY MUST BE
REPLACED.
Failure to bring the pool or spa's electrical system up to code requirements before
installing the underwater light will create an electrical hazard which could result in
death or serious injury to pool users, installers, or others due to electrical shock, and
may also cause damage to property.
1. Switch off electrical switch or circuit breaker at the source,
2. Remove Junction Box or Transformer cover. Disconnect the light wires and
attach a fish tape to the existing light power cord. This will assist in pulling
the replacement light power cord through the conduit back to the junction
box.
3. Remove the GloBrite color light assembly from the pool or spa water:
Using the provided installation tool (P/N 620057), rotate the light assembly
counter-clockwise about a 1/8th turn to release the light from the niche as
shown on page 11).
4. Slowly pull the light and attached power cord (with attached fish tape) out of
the niche. Pull the light's power cord and fish tape out of the niche and place
the light on the deck.
5. Attach the new light power cord to the fish tape and carefully feed the fish
tape and cable to the junction box.
6. Install the light into the niche: Place the light installation tool over the front
of the light. Turn the tool and light clockwise while pushing inward, until you
feel the stop point. This indicates the light is properly seated, locked and the
electrical conduit, is completely sealed (see page 11).
Note: If the light does not turn smoothly, pull the light slightly out and be sure
that it's seated properly and the niche is free of debris, then install the light
as described in step 5.
7. Connect the two (2) conductors to the corresponding circuit wires in the
Junction Box (black wire to power, white wire to common) and secure the
Junction Box cover in place.
8. Final check for proper GloBrite Color light operation: Switch on the
main switch or circuit breaker to the 12 VAC transformer and the switch that
operates the light itself. The light should illuminate when 12 VAC power is
applied. If not recheck the installation steps.
IMPORTANT NOTICE:
®
LIGHT IS A NON-SERVICEABLE LIGHT. THE
GloBrite Color Changing LED Pool/Spa Light Installation and User's Guide
13