Num'axes PIE1052 Manual De Instrucciones página 24

Image resolution
Multi-shot
Video resolution
Night mode
Flash power
Camera ID
GPS
Sendings/Day
Cam
PIR switch
PIR sensitivity
PIR interval
Time Lapse
Timer 1
Set
OK
PIR
Settings
PIR switch
24/72
24M | 12M | 8M
Higher resolution produces better quality photos but creates larger files that take up
more of the memory card capacity (fills up faster).
1P | 2P
Programmable – 1 or 2 photos per trigger
FULL HD | HD | WVGA
Video length: 10 seconds
Higher resolution produces better quality videos but creates larger files that take up
more of the memory card capacity (fills up faster).
Maximum range | Balanced | Minimum blur
− Maximum range: this setting offers a longer exposure time to extend the infrared
flash range for a better night vision (lower quality image).
− Minimum blur: this setting offers a short exposure time to minimize motion blur for
a better image quality (shortened infrared flash range).
− Balanced: this setting offers a combination of the above 2 options.
High | Low
− High: all 60 infrared LED will work
− Low: part of the infrared LED will be turned off.
ON | OFF
Select "ON" then press OK to set an ID number for the camera (12 digits/letters). Such
function can help you identify from where and from which camera the photos are.
OFF | ON
With GPS ON, the GPS information will be shown on photo stamp (if the "Time Stamp"
parameter is also set to "ON").
NOTE: if the GPS signal is weak around the product, the GPS information will not be
shown on the photo stamp until the signal gets stronger.
Unlimited | 01 – 99
Example: if you select 50, every day, the camera will only send the 50 first photos taken
to the cloud storage. The rest of the photos taken that day will not be sent but will be
stored in the memory card.
PIR Other
ON
High
ON
OFF
OFF
Exit
MENU
Programmable options (default settings in bold characters)
OFF | ON
With the PIR switch ON, the PIR sensor is turned on and the camera will be able to take
photos/videos per motion activation even when the Time Lapse setting will be ON.
With the PIR switch OFF, the PIR sensor is turned off and the camera will not be able to
take photos/videos per motion activation.
Guide d'utilisation PIE1052 – indice B – Janvier 2022
Cam PIR
Timer 2
Remote control
Set
OK
Other
OFF
Delay 1H
Exit
MENU