Wireless Operation; Configuration - Chauvet Professional onAir IP PANEL MIN Manual Del Usuario

EN

Wireless Operation

In optimal conditions, the onAir IP Panel Min can operate up to 300 m (900 ft) away from the CRMX™ transmitter, The
CRMX™ receiver in the onAir IP Panel Min must be paired with the CRMX™ transmitter for wireless operation.
Initial Setup
1. Turn the CRMX™ transmitter on.
2. Connect the CRMX™ transmitter to a DMX controller.
3. Place the onAir IP Panel Min within 300 m from the CRMX™ transmitter.
4. Turn the onAir IP Panel Min on.

Configuration

1. From the onAir IP Panel Min's control panel, go to DMX Address.
2. Select the start address, as with any other DMX compatible product.
3. Go to Wireless Setting > Receive On/Off.
4. Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5. Press the reset button on the CRMX™ transmitter. (The Signal Strength Indicator on the onAir IP Panel Min will
show a ϟ in front of the bars for 3 seconds while a connection is established.)
Product Pairing
If the onAir IP Panel Min has already been paired with the CRMX™ transmitter, the Signal Strength Indicator on top of the
display will show the strength of the signal. In this case, the onAir IP Panel Min is ready to work in Wireless mode.
Pairing the onAir IP Panel Min and a New CRMX™ Transmitter
1. From the onAir IP Panel Min control panel, go to Wireless Setting > Receive Reset.
2. Select Yes.
3. From the CRMX™ transmitter, press <RESET>. The signal indicator on the transmitter will flash.
4. Once the transmitter has found the onAir IP Panel Min, the signal indicator on the CRMX™ transmitter will
illuminate solid.
5. The display screen on the onAir IP Panel Min will show the strength of the signal.
CRMX™ operation can be interrupted or inhibited by people or liquid masses, including water or
snow, between the transmitter and receiver. For best results, keep the area between the transmitter
and receiver clear of any liquid masses.
USB Software Update
The onAir IP Panel Min allows for software update through USB using the built-in USB port. To update the software using
USB flash drive, do the following:
1. Power on the fixture and plug the flash drive into the USB port.
2. Once the flash drive has been detected, the message "Upgrade Firmware" will be displayed. Press <ENTER>. If
a different message appears on the display, search for the update software in the menu (Upgrade Firmware). A
list of the software update files will be displayed.
3. Select the file that needs to be uploaded. The message "Are you sure?" will be displayed. Press <ENTER>.
4. If the selected file is correct, the upgrade will be completed. Restart the product. If the selected file is incorrect,
the upgrade will fail, and the display will go back to the main interface. Repeat steps 1-3 using the correct file.
The .chl format file needs to be placed in the ONAIR folder in the USB flash drive.
3
QUICK REFERENCE GUIDE
onAir IP Panel Min QRG Rev. 2