Tabla De Contenido; Important Safeguards - NUTRIBULLET Juicer Manual De Instrucciones

Contents
03 Important safeguards
06 What's included
07 Assembly guide
08 Assembly & use
10 Usage instructions
13 Control dial
14 Juicing tips
18 Disassembly
20 Care instructions
21 How to store
22 Replacement Parts
Thank you for purchasing the nutribullet Juicer™.
2

Important safeguards

Warning! To avoid the risk of serious injury, carefully
read all instructions before operating your nutribullet
Juicer . When using any electrical appliance, basic
™
safety precautions should always be observed, including
the following important information.
PERSONAL SAFET Y
WARNING!
This juicer system has sharp
blades and moving parts, and
is NOT intended for use by
children who lack experience
and knowledge of its safe
operation. They require close
supervision and thorough
instruction on its proper use and
safe operation.
Keep the appliance and its
cord out of reach of children.
Children shall not play with
the appliance. To eliminate
a choking hazard for young
children, remove and safely
discard the protective cover
fitted to the power plug of this
juicer.
AVOID CONTACT WITH
MOVING PARTS.
Keep hands, fingers, hair,
clothing as well as spatulas and
other utensils away from the
appliance during operation.
This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning use
of the appliance by a person
responsible for their safety.
SIEVE AND BLADES ARE SHARP!
HANDLE WITH EXTREME CARE!
Do not touch the small cutting
blades/teeth on the bottom/base
of the sieve. Keep fingers away
from the sharp blade in the feed
chute.
Do not leave the appliance
unattended when in use.
Hard fruits and vegetables will put
excess strain onto the motor if a
low speed is selected.
If there is a spill under, around
or onto the juicer itself,
disconnect the unit from the
power source. Clean with a cloth
and allow unit to dry completely
before operating.
3