NUTRIBULLET Juicer Manual De Instrucciones página 5

Assembly
1
Motor Base
Place the on
a dry, level counter top.
Ensure the dial is set to the
"OFF" position and the unit is
unplugged.
3
Sieve
Align the with the motor
drive coupling and push
down until it clicks into place.
Sieve
Handle the by gripping
the top edges being careful
not touch the sharp teeth on
the base of the Sieve. Ensure
the Sieve is properly seated
in place and securely inside of
the Pulp Basin.
8
2
Place the Pulp Basin on top of
the Motor Base. Align the Pulp
Basin
with the Motor Base so
that the spout is aligned with
the dimpled side of the Motor
Base.
4
Place the Basin Cover over
the Sieve and Pulp Basin.
Basin
The side "ears" on the
Cover
should align with the
"ears" on the sides of the Pulp
Basin.
5
Locking Handle
Raise the and
move it into the "ears" on each
side of the Basin Cover. The
Locking Handle should be in
a vertical position and locked
into place.
NOTE: if the Locking Handle is not
securely in place, the juicer will not
power on.
7
Place the Juice Pitcher Lid on
top of the Juice Pitcher and
open the locking lid latch.
6
Swing the No-Drip Spout
cover up vertically, so that it
is no longer covering the juice
spout.
8
Juice
Slightly angle the
Pitcher
and place it under the
juice spout. Align the spout
with the hole in the Juice
Pitcher Lid
and level out the
Juice Pitcher. It will fi t snuggly
into the spout to hold it in
place.
9