GRE FAQ200 Manual De Instrucciones página 4

Preface
Many thanks for purchasing this GRE product. We continually de- velop
and enhance our items, however, should this product be faulty, we apologise
for any inconvenience and politely ask you to get in contact with our service
centre.
Read operating manual and store safely
lnstruction manual for Filter Balls Filter unit Speed Clean
This instruction manual relates to the product stated above. lt contains
importan! information on starting your product for the first time and how to
operate it. Carefully read through the instruction manual - particularly the
safety instructions - befare using this product. Non-compliance with this
instruction manual may lead to majar injuries or damage to your product.
The instruction manual is based on standards and regulations
applicable within the European Union. lf the product
abroad, please follow any country-specific guidelines and laws. Store the
instruction ma- nual in a safe location for later consultation and submission
to third parties, where applicable.
lntended use
This product is solely intended far prívate use and is not suitable for com-
mercial use. Only use the product as described in this instruction manual.
Any other use is considerad improper use and may lead to personal injury
or damage to property. This item is no! a toy. The manufacturar or retailer
assumes no liability for damage resulting from improper or incorrect use.
Warnings and safety instructions
Read and observe all instructions. Non-compliance with these war-
nings and instructions may result in damage to property, severe per- sonal
injury or even death. These product warnings, instructions and safety
regulations are extensive but cannot cover all potential risks and dangers
and are thus not to be consldered exhaustive. Please be cautious and
assess potential dangers appropriately. lncorrect use/ handling of the
product can lead to life-threatening situations.
Caution! Leave repairs to experts in order to prevent hazards. Consult a
specialist workshop. Liability is waived and warranty claims expire if
repairs are carried out independently of if the product is improperly installed
or used incorrectly. Only original parts corresponding to the original product
specifications may be used during repairs.
WARNING! Hazardous for children and persons with reduced phy-
sical, sensory or mental abilities (such as the handicapped, elderly
individuals with impaired physical and mental abilities), or those with a
lack of experience and knowledge. Children must not be allowed to
play with this product. Cleaning may not be performed by children
and persons with reduced physical, sensory or mental abilities.
NOTE! Risk of damage! This product may be damaged through
improper use.
Danger of electrocution! Faulty electrical installation or too high
mains voltage can lead to electrocution.
if the mains voltage on the socket corresponds to the technical
specifications. Only connect this product using an easily accessible
socket to ensure it can be rapidly disconnected from the mains in
the event of a fault. Do not operate the product if it exhibits visible
damage or the mains cable/plug is defective. As additional protection,
it is recommended to install a residual current device (FI/RCD) with a
tripping current of no more than 30 mA. Consult with an electrician
foradvice.
Only open the product as described in this manual. Leave repairs to
experts in order to prevent hazards. Consult a specialist workshop.
Liability is waived and warranty claims expire if repairs or changes
is being used
Only connect the product
to the product are carried out independently of if the product is
improperly connected or operated incorrectly. This product features
electrical and mechanical parts which are indispensable for protec-
ting against potential hazards.
Never touch the plug with wet hands. Never pull out the plug from the
socket using the cable - always pull on the plug. Keep the product,
plug and all cables away from open fires and hot surfaces. Lay the
cable so that it does not pose a tripping risk anddo not place it under
the ground. Lay cables in such a way that they will not be damaged
by lawn mowers and other similar devices. Do not kink the cable and
do not lay it over sharp edges. Do not use an extension cable, multip-
le socket adapters or other adapters.
Filtration systems may not run dry (without water)! The water takes
the cooling - in case of dry running there is no warranty replacement!
Never place the pump or filter in your pool. The filter system must
not be operated when the pool is in use. lnstall this product with a
sufficient safety margin from the pool to prevent children from using
the system to access the pool. Do not lmmerse the fllter system, po-
wer cable or plug in water or in any other liquids. The filter system's
pump is designed to ensure good protection against foreign bodies
and water spray. However, it should still beinstalled in such a way
to ensure adequate protection from the weather. NEVER service this
unit with the electrical power cord connected. RISK OF SUCTION
ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT IN
SERIOUS INJURY OR DEATH. Do not block pump suction at the pump
or In the pool as thls can cause severe lnjury or death.
check scope of delivery
NOTE! Risk of damage! The product may be damaged if you open the
packaging with a sharp knife or other sharp objects without due care and
attention. Please open the packaging very carefully.
• Remove the product from the packaging.
• Check that all included items
L1.
• Check whether the item, or parts thereof, exhibit damage. lf there is da-
mage, do not use the product. Get
stated at the end of the manual.
Operation
The filler balls in !he filler tank ensure that dirt particles and floating debris
are effectively filtered overa long period of time. Dirty water is drawn from
the pool via !he suction pipe through the filler pump and then fed from
above into the filler tank. As the water flows through the filler balls in the
filter tank, dirt particles are depositad in the filler balls and thus filtered out
of the pool water. The purified water then flows through the return pipe
back into the pool.
Far the operation of the filler system, you need a skimmer (surface skim-
mer). Either an integrated skimmer (built into the pool wall) ora suspended
skimmer (attachment to the poolwall).
Positioning
The installation area you set between the skimmer and the inlet nozzle so,
that there is an adequate safety margin to the pelvic wall. We recommend
putting the filler system in addition on base platas (far example: washed
concrete slabs etc.). These have to be installed with the spirit level. Under
no circumstances you may put your filler system in a trough or directly into
the grass (flood danger or risk of overheating of the filler pump).
lf you have sunk your pool partially or completely, so it makes sense to
place the filler pump in a filler slot, which should connect directly to the
pelvis. Is your filler pump housed in a filler slot, so it has to be insured,
that the filler slot can'! be slooded. Far this purpose you should bring in a
roller-bumishing (crushed rock) in the range of the filter slot, so that the
surrounding- and rainwater can seep away. lt would be ideal if there is
a direct connection to the drain in the sump of the filler shaft (or sludge
pump, with automatic floating switch). lt is importan! to ensure that the
filler slot should never be airtight, because this may cause damage, due to
condensation water, on the filler pump. The size of the filter shaft should be
selected so that work can be performed on the filler system.
4
have been delivered in ful!. Sketch/photo
in contact with the service address