LUCKY FL068 Manual De Operaciones página 13

If there are any air pockets between the
sonar senor and ice, or air on the water
below the ice, the unit will not work properly
and will require you to try another spot, or
cut a hole in the ice to use.
NOTE:
* To remove the sonar sensor from the frozen gently tap sonar sensor at the base with your hand.
If it will not come loose, spray a small amount of water on the ice surface around the base and repeat
above step until the sonar sensor is easily removed. Never use a blunt to strike the sonar sensor
as this may cause damage to the sensitive internal electronics.
* Cold weather is extremely hard on the electrical components within the display housing.
It is suggested that you keep the unit in temperatures above -17 degrees Celsius during operation.
* Remove the batteries from the fish finder to prevent battery leakage and corrosion. Clean the sonar
sensor and cable with fresh water and dry-off before storing .
Do not submerge and/or spray the fish finder screen/housing with water or use chemicals to clean.
11