Carat DS-4000 Manual De Instrucciones página 44

GB
coolant to avoid the working surface of the diamond segments from
overheating.
Water also keeps down dust and flushes away abrasive particles.
WARNING: Always use the PRCD (GFCI) when operating with
Open
Water Feed Valve
water
WARNING: Never allow water to enter the motor. It could lead to
Closed
an electric shock.
WARNING: Check all connections of the water feed system to ensure there are no leaks. Inspect hoses
and other critical parts which could deteriorate.
WARNING: The maximum water pressure should not exceed 70 psi (4 bar).
Use a water collector with a wet vacuum to collect cooling water if nearby objects could be damaged by water.
The water feed system is built into the machine. To connect with the water supply, first pull the quick-release
collar to remove the female side of the water coupling. Then unscrew the nut and engage the coupling to the
water hose. Now reconnect the water coupling to the male water feed valve. Press it until it clicks.
The water flow is controlled by the water feed valve. The water to the blade may be finely adjusted to the
required amount.
NOTE: Contaminants in the water supply can easily plug up the fine water nozzles in the blade guard.
Ensure that the supply water is clean. If you find that there is no water flow to the blade, then clean out
the water feed system on the machine.
GUIDE ROLLER ASSEMBLY
Butterfly Bolt
The guide rollers make it easier to keep the blade plane perpendicular to
the workpiece. To install, slacken the butterfly bolt slightly and engage the
four claws with the four eyelets on the bottom of the motor housing, then
tighten the butterfly bolt.
FLUSH CUTTING KIT INSTRUCTIONS
Toggle Latches
The flush cutting kit enables a flush cut blade (not included) to be
mounted to the machine which allows flush cuts to be made while
the outer blade guard is temporarily removed. The flush cut blade
may be left in place and the operator may return to standard cutting
simply by replacing the outer blade guard and securing with the 3
toggle latches. In this way, it is quick and convenient to switch
between standard and flush cutting mode. Or if desired, the flush
cutting blade and flange may be removed and the machine returned
Flat-head Socket
to the standard configuration.
Cap Screws
44