Waeco MagicWatch MWE800 Instrucciones De Montaje Y De Uso página 32

_MWE-800-4F.book Seite 32 Freitag, 21. Juli 2006 4:28 16
Safety and installation instructions
When the negative terminal of the battery is disconnected, all data stored in
the volatile memories will be lost.
The following data must be set again, depending on the vehicle equip-
ment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following instructions when mounting the camera:
Secure the parts of the MagicWatch system installed in the vehicle in such
a way that they cannot become loose under any circumstances (sudden
braking, accidents) and cause injuries to the occupants of the vehicle.
To prevent damage, when drilling ensure that there is sufficient room for
the drill head to come out on the other side (see fig. 2, page 4).
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, use only a diode test lamp
(see fig. 1.5, page 3) or a voltmeter (see fig. 1.6, page 3).
Test lamps with an illuminant (see fig. 1.9, page 3) consume voltages
which are too high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (see fig. 3,
page 4)
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulat-
ing tape, for example to existing cables.
32
All manuals and user guides at all-guides.com
MagicWatch MWE800