rear-facing and attach it on the stroller making sure that
it locks on both sides (you will hear a click on both sides
when it locks correctly) (fig. 23).
WARNING: Before use, make sure that all the child car seat
fastening devices are correctly engaged by pulling the
child car seat up.
WARNING: Never install the child car seat forward facing.
24. To release the car seat from the stroller, just press the
rear orange button as shown in figure 24 and lift the car
seat by the handle in vertical position.
WARNING: The fastening and releasing operations can be
carried out also with your child inside the car seat; however,
these operations may be more difficult to execute with the
child's weight.
FITTING AND REMOVING THE STROLLER LINING
25. To remove the lining from the structure, remove the
lateral flaps from the seat: release the 3 buttons on the
armrests and remove the flaps from the seat as shown
in figure 25.
26. Now release the buttons under the sides of the seat
(fig. 26A) and release the backrest lateral fabric flaps as
shown in figure 26B.
27. Detach the velcro strips under the seat, pull out the
crotch strap belt, remove the waist strap from the
D-shaped rings and remove the D-shaped rings from
the relevant holes in the backrest (fig. 27A); starting
from the legrest, remove the fabric (fig. 27B) until it
comes off the backrest completely (fig. 27C).
28. To easily wash the seat's fabric, open the velcro strips
at the bottom of the backrest and remove the stiff ele-
ment from the fabric (fig. 28).
To fit the lining on the stroller again, repeat the steps illus-
trated above in reverse order.
ACCESSORIES
WARNING: The accessories described below may not be
included in some product versions. Please read carefully
the instructions on the accessories available for the model
purchased.
SHOULDER STRAPS AND CROTCH STRAPS
Simplicity stroller can be provided with padded shoulder
straps and a soft crotch strap to ensure safety and comfort
of your child.
29. Fit the pads over the straps as shown in figure 29A and
fit the crotch strap inside the padding (fig. 29B).
WARNING: Adjust the width of the waist belt if needed,
pressing on the buckles.
WARNING: To ensure your child's safety, it is necessary to
always use the safety harness.
RAIN COVER
30. To fit the rain cover, fasten the straps around the stroll-
er's frame, in the positions shown in Fig. 30 (the steps
are to be repeated on both sides of the stroller). When
you have finished using the rain cover, allow it to dry
properly if it is wet.
WARNING: The rain cover cannot be used on the stroller
without canopy, as it may cause suffocation.
WARNING: when the full-cover rain cover is fitted on the
stroller, never leave it exposed to direct sunlight with the
child inside, as the temperature will rise considerably.
All manuals and user guides at all-guides.com
LEG COVER
31. To use the leg cover, firstly fasten it to the seat using
the velcro strips in the lower part of the leg cover and
under the stroller's seat (fig. 31A). The upper part of the
leg cover can be fastened in two different ways. In the
first case, to ensure your child's safety, pass the leg cover
under the bumper bar and fasten the buttons on those
in the fabric on the inner face of stroller's sides (fig. 31B).
In the other case, you need to fold the upper part of the
leg cover on itself around the bumper bar and fasten
the buttons as shown in figure 31C.
CARRY-ALL BAG
Some stroller versions might include a convenient carry-all
bag.
32. To fasten the bag to the handle, use the two strips of
fabric on the sides of the bag and fasten them with the
buttons (fig. 32).
WARNING: Do not overload. The bag must not weight more
than 2 kg.
14
IM
IN
TA
A
P
LE
M
B
H
A
• A
s
• A
t
s
• A
t
f
p
• A
v
• A
s
• L
h
s
l
j
•
d
t
a
• A
c
o
• L
t
c