Bumper Bar - Chicco Simplicity Manual Del Usuario

Ocultar thumbs Ver también para Simplicity:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
der the seat and fasten it with the two buttons (fig. 7).
ADJUSTABLE HANDLE
8. To adjust the height of the stroller's handle, press the two
side buttons (fig. 8) at the same time and move the han-
dle to the required height.
ght

BUMPER BAR

ck
9. To fit the bumper bar, fit it from above on the two pins
ust
located at the ends of the armrests until you hear it click
ra-
into place as shown in figure 9.
tic
10. To pull out the bumper bar, press the two buttons at
nd.
the extremities of the bumper bar and pull it up (fig. 10)
11. You can also open the bumper bar on one side only and
swing it open to facilitate placing your child in the seat
(fig. 11).
WARNING: The bar must not be used to lift the product with
the child inside of it.
our
ure
HOW TO USE THE SAFETY HARNESS
oll-
This stroller has a five-point safety harness featuring two
shoulder straps, two adjustment holes, a waist strap and a
he
crotch strap with buckle.
he
12. WARNING: To use it with children from birth to approx.
1B.
6 months of age, you must use the shoulder straps by
ick
threading them first through the two adjusting holes
(fig. 12). After laying the child in the stroller, fasten the
ed
straps (Fig. 12) by passing first the two forks (A) inside
lly
the shoulder strap buckle (B) and then inside the crotch
strap buckle (C); Adjust the height of the shoulder straps
so that they adhere to your child's shoulders. Make sure
that the harness straps are fitted correctly. To unfasten
ed
the waist strap, press and pull the side prongs.
her
WARNING: Children must wear all the time the safety har-
ness. To ensure your child's safety, it is necessary to always
tly
use the safety harness.
WARNING: after removing the waist strap (e.g., for wash-
ing), make sure to reassemble it correctly by threading it
through the 2 rings D. The harness must be re- adjusted. To
make sure that the belts are fastened properly to the an-
w-
choring points, after placing your child inside the stroller,
pull the end parts of the belts firmly.
HOW TO ADJUST THE BACKREST
The backrest can be adjusted to 4 positions.
13. To recline the backrest, lift the adjuster handle on the
back of the backrest (fig. 13) and pull it down.
14. To raise the backrest, simply lift it to the desired position,
ed
without pressing on the handle (fig. 14).
gh
WARNING: The child's weight can make these operations
he
more difficult.
REAR BRAKES
ou
The rear wheels have linked brakes, which can be applied
simultaneously on both rear wheels by using one pedal
be-
alone.
15. To apply the brakes, press one of the two pedals on the
sides of the rear wheels down, as shown in figure 15.
16. To release the brakes, press one of the two pedals on the
ler
sides of the rear wheel group up, as shown in figure 16.
of
SWIVEL WHEELS
ant
17. To make the front wheels swivel, lift the lever fitted
un-
All manuals and user guides at all-guides.com
between the two wheels. Use the swivel wheels on
smooth surfaces. To use the wheels in fixed mode, press
the lever downwards again (fig. 17).
WARNING: the swivel wheels make the stroller easier to di-
rect; it is recommended to use the wheels in fixed mode
on uneven ground to guarantee better stability (on gravel,
unpaved roads, etc.)
WARNING: Both wheels must always be locked or unlocked
at the same time.
SUN CANOPY
18. To fit the canopy, fasten the plastic clip to the frame's
tube and the velcro strips in the appropriate positions,
as shown in figure 18.
WARNING: The canopy must be fixed on both sides of the
stroller. Ensure that the hood is correctly secured into posi-
tion.
To remove the canopy from the frame, detach the velcro
strips and the plastic clips.
19. To open the canopy, push the front arch forward as
shown in figure 19. To close it, repeat the steps in re-
verse order.
20. The canopy has a transparent window to ensure bet-
ter visual contact and control of your child. The window
can be closed or opened using the relevant fabric flap
as shown in figure 20.
ADJUSTABLE LEGREST
The legrest can be adjusted in 2 positions.
21. To lower the legrest, hold the legrest bar and pull it out,
then turn it down (fig. 21). To raise the legrest up from the
down position, just pull it up.
FOLDING THE STROLLER
WARNING: When opening the stroller, make sure that your
child or other children are at a safety distance. Make sure
that during these operations the moving parts of the stroll-
er will not come into contact with your child before closing
the stroller, make sure that the storage basket is empty and
the canopy is closed.
The stroller has a closing device that can be used with one
hand.
22. To close the stroller, push switch A to the left and press
button B at the same, as shown in figure 22. Push the
handle forward to fold the structure (fig. 22A). The
stroller will lock automatically in closed position. When
closed, the stroller stands on its own. To close the stroller
in a compact manner (fig. 22B), the handle can be fold-
ed into closed position as described in item 8.
USING THE KEYFIT CAR SEAT ON THE STROLLER
The Keyfit car seat can be attached on Simplicity stroller.
WARNING: Before using the stroller in combination with the
car seat, always check that the hook-on system is correctly
locked in place.
When fastened to the stroller, the Keyfit car seat can be
used for children from birth up to 13 kg in weight or until
they are able to sit independently.
With the stroller open, fold the sun canopy and recline the
backrest completely.
WARNING: To use it with the child car seat, the bumper bar
must not be removed.
23. Position the car seat's handle vertically with the car seat
13

Publicidad

Tabla de contenido
loading

Tabla de contenido