Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY OF SINGLE CULTIVATOR
The following instructions describe the two types of disc
arrangement. The discs can also be mounted farther
apart by using the outer slots in the tray.
5. Assemble the disc assemblies to the tray using four
3/8" x 1-1/4" carriage bolts and 3/8" nylock nuts.
Swivel the disc assemblies so that the carriage bolt is
centered in the angle adjustment slot. Tighten. This
places the discs at the standard 15 degree angle.
See figures 4 and 5.
CONCAVE (DISHED) SIDE OF DISC FACES OUTWARD.
ANGLE
ADJUSTMENT
SLOT
FIGURE 4
CONCAVE (DISHED) SIDE OF DISC FACES INWARD.
FIGURE 5
3/8" x 1-1/4"
CARRIAGE BOLT
3/8" NYLOCK NUT
3/8" x 1-1/4"
CARRIAGE BOLT
ANGLE
ADJUSTMENT
SLOT
3/8" NYLOCK NUT
ENGLISH
ASSEMBLY OF TANDEM CULTIVATORS
(Requires purchase of a second cultivator.)
The front cultivator should be assembled as shown in
figure 4. The rear cultivator should be assembled using
the following instructions. Note that the position of the
tray and drawbar are the reverse of the front cultivator.
6. Assemble the disc assemblies to the outer slots in the
tray using four 3/8" x 1-1/4" carriage bolts and 3/8"
nylock nuts. Swivel the disc assemblies so that the
carriage bolt is centered in the angle adjustment slot.
This places the discs at the standard 15 degree angle.
Tighten. See figure 6.
CONCAVE (DISHED) SIDE OF DISC FACES INWARD.
FIGURE 6
6
3/8" x 1-1/4"
CARRIAGE BOLT
ANGLE
ADJUSTMENT
SLOT
THIS END
AT FRONT
3/8" NYLOCK NUT
Publicidad
Tabla de contenido
