Start-Up; Parachute Cables; Maintenance; Repairs - APRITECH HOME 60 Manual Del Usuario

12 START-UP

After installation, make sure that no part of the door
interferes with public spaces such as pavements and/or roads.
Check the status of the unit's inputs and make sure that all the safety
devices are correctly connected (the relevant LEDs must be lighted).
Run a few complete cycles to check if the automated system
and the accessories connected to it are operating correctly,
addressing special care to the safety devices and the
anti-crushing device of the operator. Check if the automated sy-
stem is able to detect an obstacle with a height of 50mm laid on
the ground.
Apply the stickers indicating the release manoeuvre near the auto-
mated system. Apply the danger signal sticker (Fig. 32), so that it is
clearly visible, near to the door or near to the control device.
Hand the customer the page entitled "User's guide", and describe
how the system works, and the operator release and locking opera-
tions indicated in the guide.

13 PARACHUTE CABLES

Connect the parachute cables to the rear door and to the ceiling
lamp to prevent accidental falls (Fig. 33).

14 MAINTENANCE

Run a functional check of the system at least every 6 months, with
special attention to the efficiency of the safety and release devices.
Once a month: check the efficiency of the anti-crushing device
and also check if it is able to detect a 50mm high obstacle laid on
the ground.
15

REPAIRS

The User must not in any way attempt to repair or to take direct action
and must solely contact qualified personnel.
14
Fig. 32
Fig. 33