Software Installation - Renishaw SPA3-2 Manual Del Usuario

SPA3-2 installation guide
www.renishaw.com
Installation software
UCCassist-2
The SPA3-2 is installed using the Renishaw UCCassist-2 program as part of the commissioning and maintenance process of a UCC controlled
CMM.
Capabilities of the software include:
Controller configuration for individual machine hardware
Machine system diagnostics
Operation with Renishaw's machine checking gauge, enabling the user to complete frequent volumetric accuracy tests to ensure the CMM
is running within the specified operational tolerances
Automated CMM error mapping routines, when used in conjunction with the Renishaw ML10, XM600 or XL80 laser systems
Automated firmware update for all UCC and SPA products
CAUTION: Do not power down the SPA3-2 whilst parameters or firmware are being updated. This may cause an error requiring
the unit to be returned to Renishaw.

Software installation

The new features of SPA3-2 are supported in UCCsuite 5.1 and later. The software can be obtained online at
or from your local Renishaw supplier. Follow the prompts to install the UCCserver software.
WARNING: The SPA3-2 must only be commissioned through Renishaw software. Failure to do so may result in unexpected
machine movement.
Issued 08 2020
www.renishaw.com/cmmsupport
15