SPC HESTIA Manual De Usuario página 24

Take into account that the maximum distance between the
thermostat and heat link is 100 metres in the open air.
Remove your old thermostat, disconnecting the wires connected
to it. These wires are the signal that control turning your boiler
on and off; before disconnecting them from your old thermostat,
check what each one is connected to in order to connect them
to the new thermostat in the same way (COM and NO on the
connection box).
1 Mark the holes on the wall and
H E A T L I N K H E S T I A
drill the holes using a drill, or place
the cover over the junction box
3
After connecting the wires (see
opposite image) put the batteries
into the thermostat and centre it
with the lower cover
Open the Heat Link using a
1
flathead screwdriver, pry
between the two notches on
the bottom
H E A T L I N K H E S T I A
≤ 100m
2 Screw the cover on by putting the
≤ 100m
boiler wires through the hole in
the middle
4
Press on all four corners until the
thermostat is properly secured
Connect the power wires to the
2
connection terminals
24
Power wire
Open
1
flathe
betw
the b
Take car
connecti
in case y
turn off t
your elec
avoid ac