Manual Mode - SPC HESTIA Manual De Usuario

To configure your own programming mode, you have two options,
the first simply and intuitively from the SPC IoT application, and
the second is done manually on your thermostat.
To go into configuration mode manually, press and hold down the
button for 3 seconds, then the days of the week will be displayed
from Monday until Sunday. You can set the schedule so every
day is the same, so the weekend and weekdays have different EN
schedules, or for each day to be different, in order to do this press
the and arrows and you can see how the selected days
change (with the ones you are going to configure being displayed).
Once the days are selected, press in order to continue with in
the configuration, now you will have to first select the time with
the arrows, and once the time has been selected, press again to
configure the temperature. Perform this same action for all of the
time periods (you can have 4 or 6 periods a day, see page 36) for
all of the days you want.
To save and leave configuration mode, press the button.
If the button is not pressed for 10 seconds while the configuration
is being undertaken, the mode will automatically be exited without
saving the changes.
To go back to the default setting, press and hold the button for
4 seconds while in the configuration mode until "dEF" is shown
on the display.

5.2 Manual mode

You can manually set the temperature you want at any time,
whether from the SPC IoT application or from the thermostat.
To do so from the thermostat, press or in normal mode to
select the temperature you want (it will be displayed on the lower-
right of the screen below the word Set) and the icon will appear
on the display to inform you that it is in manual mode.
33