Monitor; Scan - Midland BR02 Manual Del Instrucciones

Monitor

The Monitor feature is for excluding (opening) the Squelch, in order to li-
sten to signals that are too weak to keep the Squelch permanently opened.
Hold down the Function key 1 to enable such function.

Scan

1. To begin scanning, press and hold the Scan button for 3 seconds. Your
radio will beep twice alerting you that the radio has entered the scan
mode.
2. When in Scan Mode, the radio will rapidly scan through all program-
med channels and will pause on any active channel. While Scan Fun-
ction is active the Green LED will flash to indicate that the radio is
scanning.
3. After stopping on an active channel, scanning will resume once there
has been 4 seconds of no activity on the channel.
4. To reply to a received transmission when the Scan Mode is enabled,
press and hold the PTT button (on radio or headset accessory) while
the radio is paused on the active channel, the radio will then transmit
on the active channel's frequency. The radio will remain on the active
channel for 4 seconds after the PTT button is released.
5. To transmit on the frequency selected by the Channel Knob while
Scan Mode is enabled, the user will verify that the radio is not re-
ceiving a transmission, then press PTT button (on radio or headset
accessory). Once the PTT button is released the radio will go back
into scanning after 4 seconds of inactivity.
6. To exit Scan Mode, the user will Long Press (≥ 3 seconds) the Scan
Button.
The radio will emit a single beep, alerting the user that the radio has exited
the Scan Mode.
6 | BR02 instruction guide