Portable Air Conditioner Care; Draining The Air Conditioner; Cleaning The Outside; Cleaning The Air Filter - Hisense AP1019CR1G Instrucciones De Uso E Instalación

Draining the Air Conditioner

A. Primary drain cover B. Primary drain plug
WARNING
Excessive Weight Hazard
Use two or more people to move and install the air
conditioner.
Failure to do so can result in back or other injury.
1. Unplug the air conditioner or disconnect power.
2. Move the air conditioner to a drain location or outside.
NOTE: To avoid leaking water from the unit, move the air
conditioner slowly and keep it level.
3. Remove the primary drain cover and
4. Drain water completely through
NOTE: If the air conditioner will be stored after use, see

"Storing After Use".

5. Reinstall the drain plug to the primary drain hole.
6. Reinstall the primary drain cover to the drain hole.
7. Reposition the air conditioner.
8. Plug in the air conditioner or reconnect power.

Cleaning the Outside

1. Press ON/OFF to turn off the air conditioner.
2. Unplug the air conditioner or disconnect power.
3. Remove the air filter and clean separately. See "cleaning the
Air Filter . "
4. Wipe the outside of the air conditioner with a soft, damp
cloth.
5. Plug in the air conditioner or reconnect power.
6. Press ON/OFF to start the air conditioner.

PORTABLE AIR CONDITIONER CARE

plug .
the drain hole .

Cleaning the Air Filter

A. Evaporator air intake filter panel
B. Condenser
NOTE:
Storing After Use
If the air conditioner will not be used for an extended
period of time:
1. Drain the water completely. See "draining the Air
Conditioner . "
2. Run the air conditioner set to Fan Only for approximately
12 hours to dry the air conditioner.
3. Unplug the air conditioner.
4. Remove the flexible exhaust hose and store with the air
conditioner in a clean, dry area. See installation
Instructions . "
5. Remove the window kit and store with the air conditioner in a
clean, dry area. See " Installation Instructions . "
6. Remove the filter and clean. See Cleaning the Air Filter.
7. Clean the outside of the air conditioner. See "Cleaning the
Outside . "
8. Reinstall the filter.
9. Remove the batteries and store the remote control with the
air conditioner in a clean, dry area.
Before using the air conditioner again:
1. Make sure the filter and drain cap are in place.
2. Check the power cord to make sure it is in good
condition, with no cracks or damage.
3. Place new batteries in the remote.
4. Install the air conditioner. See "Installation Instructions".
15
door
air intake filter panel door
"