Assembly; Carton Contents; Install Wheel Kit - Briggs & Stratton PowerBoss 030217 Manual Del Propietário

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the data tag
available.
Remove Generator From Carton
1. Set carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
2. Carefully open top flaps of shipping carton.
3. Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
4. Remove all packing material, carton fillers, etc.
5. Remove generator from shipping carton.
Figure 1 — Install Wheel Kit
Capscrew
Nut
Handle
Mounting Leg
5250W Portable Generator

Carton Contents

Check all contents. If any parts are missing or damaged, call
the generator helpline at 1–800–743–4115.
• The generator
• Generator and engine owner's manuals
• Engine oil
• Three packets of fuel stabilizer
• Wheel kit

INSTALL WHEEL KIT

NOTE: While the wheel kit is designed to greatly improve
the portability of your generator, it is not intended for
over-the-road use.
You will need two 1/2" or 13mm open end wrenches or a
socket wrench with 1/2" or 13mm sockets and a needle-
nose pliers to install this kit.
Refer to Figure 1 and install the wheel kit as follows:
1. Place the bottom of the generator frame on a flat, even
surface.Temporarily place unit on blocks to ease
assembly.
Axle
Capscrew
Nut
6
Wheel
Washer
E-Ring