Assembly; Unpack Generator; Install Wheel Kit - Briggs & Stratton Power Boss Manual Del Operario

Assembly

Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended oil
and fuel.
If you have any problems with the assembly of your generator,
please call the generator helpline at 01 800 227 44 47. If
calling for assistance, please have the model, revision, and
serial number from the identification label available. See
Generator Features and Controls for identification label
location.

Unpack Generator

1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
The generator is supplied with:
• Operator's manual
• Wheel kit

Install Wheel Kit

NOTICE Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 13 mm wrench
• Socket wrench with a 13 mm socket
• Pliers
• Safety glasses
L
J
K
M
H
N
E
Install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Place a wheel (B) on each side as shown below.
4. Place a washer (C) on axle and then place an e-ring (D)
in axle groove.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
CAUTION E-rings could cause eye injury.
E-rings could spring back and become airborne
when installing or removing, resulting in
moderate injury.
• Always wear eye protection when installing/removing e-rings.
6. Repeat steps 4 and 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Line up holes in support leg (E) with holes in generator
frame.
9. Attach support leg using two short capscrews (M8 x
20 mm) (F) and two flange nuts (G). Tighten with a
13 mm socket and wrench.
10. Attach handles (H) to brackets on generator frame as
shown, with 45 mm capscrews (J), flat washers (K),
nylon washers (L), and M8 lock nuts (M).
NOTICE
DO NOT overtighten. Handles must be able to
move up and down freely.
11. Return generator to normal operating position (resting
on wheels and support leg).
12. Loop handle pins (N) on generator frame just above
handle brackets.
13. Raise handles and insert handle pins to move generator.
Always face generator when moving.
F
G
A
B
D
C
7