LawnMaster NPTGCP2617A Manual Del Operador página 12

ASSEMBLY
■ Slide the debris guard onto the curved shaft all the way down to the correct mounting position
as shown (Fig. 1).
■ Align the screw hole on the debris guard with the screw hole on the bracket. Insert the screw
through the grass deflector and the bracket on the shaft (Fig. 2).
■ Secure the screw tight using the screwdriver (Fig. 3).
INSTALLING AND REMOVING THE SHAFT
Never install, remove, or adjust any attachment while the engine is running. Failure to stop the engine
can cause serious personal injury.
To install the shaft:
■ Loosen and remove the knob from the shaft connection sleeve.
■ Check to ensure the axles in the shafts are aligned as shown (Fig. 4). If not aligned, slightly
rotate the trimmer head to adjust the axle until it aligns.
■ Push in the button located on the shaft. Align the button with the positioning hole on the shaft
connection sleeve. Slide the shaft into the shaft connection sleeve until the button locks into the
positioning hole (Fig. 5).
Hole on
the debris
guard
Fig. 1 Fig. 2
Hole on
the
bracket
(See Figs. 4-6)
Fig. 4
12
Fig. 3