LawnMaster NPTGCP2617A Manual Del Operador página 13

ASSEMBLY
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked
into place. Slightly rotate from side to side until the button is locked into place.
■ Secure the shafts tight using the knob by turning it clockwise (Fig. 6).
Button Positioning Hole
Ensure that the knob is fully tightened before operating the tool; check it periodically for tightness
during use to avoid serious personal injury.
To remove the shaft:
■ Stop the engine and remove the battery pack.
■ Loosen the knob.
■ Push in the button and twist the shafts to remove and separate ends.
INSTALLING AND REMOVING THE SHAFT
To install the battery pack:
■ Align the battery pack with the battery slot.
■ Insert the battery pack into the battery slot until the battery pack secures into place. Make sure
the battery inserted in the correct direction (Fig. 7).
■ Do not use force when inserting the battery pack. It should slide into position and "click".
To remove the battery pack:
■ Locate the battery release button, press and hold the button up (Fig. 8).
■ Slide the battery pack off the battery slot.
Fig. 7
WRONG
13
Tight
Fig. 5
(See Figs. 7-8)
Loosen
Fig. 6
Battery Release Button
Fig. 8