PeakTech 3335 Manual De Instrucciones página 27

* Do not conduct voltage measurements with the test leads connected
to the mA/A- and COM-terminal of the equipment.
* The 10A-range is protected. To avoid damage or injury, use the meter
only in circuits limited by fuse or circuit breaker to 10A or 2000VA.
* To avoid electric shock, disconnect power to the unit under test and
discharge all capacitors before taking any resistance measurements.
* Do not conduct current measurements with the leads connected to the
V/-terminals of the equipment.
* Check test leads and probes for faulty insulation or bare wires before
connection to the equipment.
* To avoid electric shock, do not operate this product in wet or damp
conditions. Conduct measuring works only in dry clothing and rubber
shoes, i. e. on isolating mats.
* Never touch the tips of the test leads or probe.
* Comply with the warning labels and other info on the equipment.
* Do not turn the rotary function switch during voltage or current
measurement, otherwise the meter could be damaged.
* Do not input values over the maximum range of each measurement to
avoid damages of the meter.
* Always start with the highest measuring range when measuring
unknown values.
* Use caution when working with voltages above 35V DC or 25V AC.
These Voltages pose shock hazard.
* Do not operate the equipment near strong magnetic fields (motors,
transformers etc.).
* Do not subject the equipment to direct sunlight or extreme
temperatures, humidity or dampness.
* Do not subject the equipment to shocks or strong vibrations.
* Keep hot soldering irons or guns away from the equipment.
* Allow the equipment to stabilize at room temperature before taking up
measurement (important for exact measurements).
Replace the battery as soon as the battery indicator "BAT" appears.
*
With a low battery, the meter might produce false reading that can
lead to electric shock and personal injury.
* Fetch out the battery when the meter will not be used for long period.
* Periodically wipe the cabinet with a damp cloth and mid detergent. Do
not use abrasives or solvents.
-26-