Replacing The Fuse - PeakTech 3335 Manual De Instrucciones

7.2. Replacing the fuse

WARNING!
To avoid electric shock disconnect the test leads before removing the
battery or the fuse. Replace only with the same type of battery or fuse.
Service should be performed only by qualified personnel.
Caution! For continued protection against fire or other hazard, replace
only with a fuse of the specified voltage and current ratings.
F1 200 mA / 600 V F; 5x20mm
F2 10 A / 600 V F; 6,3x32mm
Follow these steps to replace the fuse:
1. Turn off the meter and disconnect the test leads.
2. Remove the rear cover by unscrewing the 5 screws and pulling
off the meter's cover.
3. Install the new fuse in the fuse compartment.
4. Replace the cover and secure it with the screws.
WARNING!
Do not operate the meter before the case cover has been closed and
screwed safely.
-46-