Stihl MS 194 T Manual De Instrucciones página 26

English
Mounting the guide bar
7
8
Turn the screw (7)
N
counterclockwise until the tensioner
slide (8) butts against the left end of
the housing slot.
9
10
Fit the guide bar over the stud (9)
N
and engage the peg of the tensioner
slide in the hole (10).
Fitting the Chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
24
11
Fit chain around the sprocket (11)
N
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
7
Turn the screw (7) clockwise until
N
there is very little chain sag on the
underside of the bar – and the drive
link tangs are engaged in the bar
groove.
Refit the chain sprocket cover –
N
the pivot pin on the hand guard must
engage the sleeve – and then screw
the nut onto the stud finger-tight.
Go to chapter on "Tensioning the
N
Saw Chain"
MS 194 T