Assembly Instructions; Features; Control Panel - Schumacher Electric SP1296 Manual Del Usuario

8.3 USING AN EXTENSION CORD
The use of an extension cord is not recommended. If you must use an extension
cord, follow these guidelines:
• Pins on plug of extension cord must be the same number, size, and shape as
those of plug on charger.
• Ensure that the extension cord is properly wired and in good electrical condition.
• Wire size must be large enough for the AC ampere rating of charger, as
specified below:
Length of cord (feet)
AWG* size of cord
*AWG-American Wire Gauge
9.

ASSEMBLY INSTRUCTIONS

9.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.

10. FEATURES

11. CONTROL PANEL

CLAMPS REVERSED/BAD BATTERY (red) LED flashing:
The connections are reversed.
CLAMPS REVERSED/BAD BATTERY (red) LED lit: The charger has
detected a problem with the battery. See Troubleshooting for more information.
CHARGING (yellow/orange) LED lit: The charger is charging the battery.
CHARGED (green) LED pulsing: The battery is fully charged and the charger
is in maintain mode.
NOTE: See Operating Instructions for a complete description of the charger modes.
25 50
18 18
1
3
4
• 8 •
100 150
18 16
1. Charging status LEDs
2. 12V accessory plug
(quick-connect)
3. Battery clamps (quick-connect)
4. Ring connectors (quick-connect)
2