Makita LS1017 Manual De Instrucciones página 9

1
1. Screw holding the laser unit box
010389
Laser line is factory adjusted so that it is positioned within
1 mm (0.04") from the side surface of the blade (cutting
position).
Cleaning of the lens for the laser light
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the
lens for the laser light carefully with a damp, soft cloth.
Do not use solvents or any petroleum-based cleaners on
the lens.
NOTE:
When laser line is dim and almost or entirely
•
invisible because of the direct sunlight in the indoor
or outdoor window-by work, relocate the work area
to a place not exposed to the direct sunlight.
Replacing the dry cells for laser unit
010399
1
010259
Remove the lid for the dry cells for laser unit by sliding
while pressing it. Take out the old dry cells and put the
1. Dry cell
9
new ones as shown in the figure. After replacing, return
the lid to cover it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Storage of socket wrench with hex wrench on
its other end
010240
The socket wrench is stored as shown in the figure. When
using the socket wrench, pull it out of the wrench holder.
After using the socket wrench, return it to the wrench holder.
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
1
010228
Lock the handle in the raised position by pushing in the
stopper pin.
1
010390
1. Socket wrench
2
with hex wrench
on its other end
2. Wrench holder
1
1. Stopper pin
2
1. Socket wrench
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4