SCHÜTTE HAITI Instrucciones De Montaje página 21

• CAUTION DANGER OF WATER DAMAGE!
Before installation please ensure that there
are no water pipes where you are intending
to drill.
• Examine the wall before installation and
choose suitable installation fixings.
We have supplied fixings suitable for an ordi-
nary solid masonry wall.
• Please note that seals are wear parts and
therefore will require to be replaced from
time to time.
• Warning - risk of electrocution! Make sure
that there are no electrical power lines where
you are drilling before starting to drill holes.
Installation Instructions
• Shut off the water supply before beginning
installation
• Check all connections carefully after first-time
use to make sure that they are tight.
• We do not assume any warranty for incorrect
installation - in particular for subsequent
damages!
Note: A 23 mm spanner is required for the
installation of the shower hose. Please do not
use a pipe wrench!
Instructions for care
Sanitary taps require special care. Therefore,
please observe the following instructions:
• Chrome-plated surfaces are sensitive to lime-
dissolving agents, acidic cleaning agents and
all kinds of abrasives.
• Never clean coloured surfaces with abrasive,
corrosive, or alcoholic agents.
• Only clean your taps with clear water and a
soft cloth or a shammy.
Surface damage is to be expected, if the care
instructions are not observed. This makes any
warranty claims invalid.
Do not forget to unscrew the mixing nozzle
in regular intervals and to remove possibly
calcareous residues or foreign matter. It is
advisable to replace the mixing nozzle with a
new one in the case of extreme contamination.
Disposal
Your washbasin tap is delivered in a solid pa-
ckaging, in order to protect it against transport
damages. The packaging consists of recyclable
materials. Dispose it in an environmentally sui-
table manner. Do not throw the product into
the normal domestic waste at the end of its
service life, but ask your municipal administra-
tion about the possibility of an environmental-
ly friendly disposal.
Maintenance
• Please check all joints and connections for
leaks or visible damages at regular intervals.
• In case of any leaks or visible damages to
the fitting or connection hoses, these should
be immediately checked by a specialist and
replaced if necessary.
• Please shut off the water supply to items
with a water-stop function, otherwise water
damages can occur.
Decommissioning
• Cut off the water supply before dismantling
the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order
of the assembly instructions.
 The illustrations are to be considered as
figurative representations, deviations of
the product are possible. Subject to
technical modifications.
21