GE JGP990 Manual Del Propietario E Instrucciones De Instalación página 26

10 PREPARE THE COOKTOP
Remove the vent grille, vent filter, sealed burner
module and the tape from the burner caps.
Turn the cooktop over (upside down) and gently
place it on the styrofoam packing.
Unscrew (loosen) the side hold-down screws.
Use styrofoam
to protect cooktop
Install the plenum to the cooktop using 4 screws.
The motor opening on the box goes toward
the left side of the unit (the side with the grease
jar lid).
Installation Instructions
INSTALL THE COOKTOP
Loosen side hold-
down screws
26
10 PREPARE THE COOKTOP
Rotate the cooktop and plenum forward and
carefully set it on its back edge on the styrofoam
packing.
Install the blower assembly onto the plenum so
that the blower exhaust is pointing down or back
as needed. Push the bolts through the bolt holes
in the plenum.
From the vent opening in the top of the
cooktop, install the vent guard over the bolts.
Use the 4 nuts to secure the blower assembly
and vent guard to the inside of the plenum.
4 Nuts
(3/8" socket
required)
(cont.)
For back exhaust,
position blower
outlet in direction
of this arrow
For down exhaust,
position blower
outlet in direction
of this arrow
Vent guard