Sony PlayStation 2 SCPH-79001 Manual De Instrucciones página 51

Picture noise appears on the TV screen.
, Check that the disc is clean and does not have any scratches. If the disc is dirty,
clean it ( page 7).
, If you move the console from a cold to a warm location, allow the console to
adjust to room temperature before use.
, If moisture condensation occurs, remove the disc and do not use the console for
several hours until the condensation evaporates (
, For some output connectors on a TV, the component video out setting needs to
be set. Check that the correct settings have been made (
, Some TVs may experience a bouncing effect in their pictures when using the
PlayStation 2 console. If this happens, connect the console to another TV.
®
, Some PlayStation
format software titles may not perform properly on the
®
PlayStation 2 console. For more information, contact SCEA Consumer Services
®
at 1-800-345-7669.
There is no picture or picture noise appears when playing a DVD.
, When playing a DVD, connect the console to the TV directly (
the video signal from the console is coming through a VCR to the TV, copy
protection on some DVDs may affect picture quality.
, If the console is connected to a TV or cable* that does not support progressive
scan (480p), no image will be displayed when you set "Progressive" to "On" in
the Control Panel. Clear the "Progressive" setting (
noise appears when using a TV that supports progressive scan (480p), also clear
the "Progressive" setting.
* The component AV cable (sold separately) is compatible with progressive
scan.
, If a DVD-R or DVD-RW disc is not finalized, it cannot be played.
, Content of a video recorded on CPRM-compatible DVD-R or CPRM-compatible
DVD-RW discs cannot be played on the PlayStation
, See also "There is no picture on the TV screen" and "Picture noise
appears on the TV screen".
The aspect ratio does not change even when playing a DVD with the
aspect ratio setting adjusted and/or playing a DVD with the aspect ratio
set to 16:9.
, Depending on the DVD or TV, the aspect ratio cannot be changed.
, Check that the console is connected to the TV directly. If there is a selector or
The size of the video image and the TV screen do not match.
, Set the aspect ratio to match your TV screen (
page 8).
page 39).
Sound
There is no sound.
, Switch the input mode of the TV (or VCR) as appropriate for the connector in
, Check that the TV volume is not set to "mute". Also check that the TV volume
, If the console is connected to an audio device, check the settings on the
page 12). If
, Try using another compatible AV cable (
, Some PlayStation
pages 31, 41). If picture
Sound quality is poor.
, Check that the disc is clean and does not have any scratches. If the disc is dirty,
, If you move the console from a cold to a warm location, allow the console to
2 console.
®
, If moisture condensation occurs, remove the disc and do not use the console for
, Some PlayStation
receiver (AV amplifier) connected between the console and TV, depending on
the type of device connected, the aspect ratio cannot be changed.
setting does not work, try adjusting the aspect ratio of your TV. Refer to the
instructions supplied with your TV for details.
use on the console.
level is set properly.
connected device. Refer to the instructions supplied with the device for details.
with the AV cable in use.
2 format software titles do not support audio output from the
®
DIGITAL OUT (OPTICAL) connector. Connect the console to the audio device
using an analog AV cable, such as the supplied AV cable (
clean it ( page 7).
adjust to room temperature before use.
several hours until the condensation evaporates (
format software titles may not perform properly on the
®
PlayStation 2 console. For more information, contact SCEA Consumer Services
®
at 1-800-345-7669.
page 30). If changing the
page 12). There may be a problem
page 11).
page 8).
Troubleshooting
US
51