Sony PlayStation 2 SCPH-79001 Manual De Instrucciones página 53

, The Parental Control feature may be set on the disc. Follow the on-screen
instructions and temporarily raise the level of Parental Control (
You forget your password.
, You can clear the password using the following procedure. If you are already
playing a DVD and at the password confirmation screen, eject the inserted disc
before following the procedure.
1
Start a DVD, and then stop playback.
Clear Resume Play ( page 25). Use a DVD without the Parental Control
feature.
2 At the Control Panel, select
( page 23).
3 Select "Parental Control", and then press the
The screen to enter a password is displayed. If the screen to register a
password is displayed, no password had been registered before. In this case,
register a new password.
4
Press the SELECT button.
The screen to clear the password is displayed.
5
Enter the number "7444".
The registered password is cleared, and the screen for registering a password
is displayed. Enter a new password (
Some functions are not available.
, Depending on the DVD, some functions may not be available:
• Stop, Search, Slow, Program Play, Shuffle Play or Repeat Play may be
prohibited.
• The audio language cannot be changed on discs that do not have multiple audio
tracks. Also, some DVDs do not allow the audio language to be changed.
• If multilingual subtitles are not recorded on the DVD, you cannot change the
language for the subtitles. It may not be possible to change the subtitle
language or turn the subtitles off.
• If multiple angles are not recorded on the DVD, you cannot change the viewing
angles. Changing the viewing angles may be prohibited.
• You can only select when playing a DVD-RW disc (VR mode).
Check whether a DVD-RW disc (VR mode) is inserted in the console.
page 33).
and then press the button
button.
page 32).
Some DVD settings cannot be changed.
, Some settings cannot be changed during playback or Resume Play (
Stop playback completely or clear Resume Play (
to adjust the settings.
Network
A connection to the network cannot be established.
, A PlayStation
2 format software title marked as compatible with the network
®
adaptor (for PlayStation 2) is not being used. Insert a PlayStation
®
software title marked as compatible with the network adaptor in the console.
, Check that the network cable is properly connected (
, Check that you are using the correct type of network cable (
, Your network cable may be damaged. Try using a different network cable of the
same type.
, Check that the network settings are correct. Refer to the instructions supplied
with the online start-up disc, software in use or information from your broadband
Internet service provider and adjust the settings accordingly.
, Check that the network settings of the network device (router, hub, repeater or
switch) in use are correct. Also check that the device is properly connected to a
power source and that all of the cables are securely connected. Refer to the
instructions supplied with the network device for details.
, The network may be busy. Wait a few minutes, and then try to access the network
again.
, Your ISP network may be down. Contact your Internet service provider to
inquire about possible service outages.
, You are using a NAT (network address translation) device or a router, hub or
switch that is not compatible with the PlayStation
device, connect your console directly to your cable/DSL modem and update your
network settings for direct connection.
, You are using an Internet service provider that is not compatible with the
PlayStation 2 console. For details, refer to the instructions for the software in
®
use or contact your Internet service provider.
page 29).
page 25) before attempting
US
2 format
®
page 44).
pages 43, 44).
2 console. Remove the
®
Troubleshooting 53