Tabla de contenido
Publicidad
Groove
Ouverture
Ranura
End Cap
Bouchon
Tapa de
extremo
Replacing Belt
Reinstall agitator back into nozzle
housing grooves.
Close rear belt cover and reinstall felt
packing.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
Cleaning Agitator
Clean agitator after every five uses
and every time the belt is replaced.
Remove lower plate.
Cut off any carpet pile and lint
entangled around agitator with a pair
of scissors.
Remove agitator.
Remove any string or debris located
on the end caps, washers or agitator
shaft.
Reinstall agitator and lower plate.
- 30 -
Publicidad
Tabla de contenido
