Location Of Your Washer; Rough-In Dimensions - GE GFWH2400 Manual Del Usuario

LOCATION OF YOUR WASHER

Do Not Install the Washer:
1. In an area exposed to dripping water or outside
weather conditions. The ambient temperature should
never be below 60°F (15.6°C) for proper washer
operation.
2. In an area where it will come in contact with curtains
or drapes.
3. On carpet. The floor MUST be a hard surface with
a maximum slope of 1/2" per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate
or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use 3/4" impregnated
plywood sheet solidly attached to the existing floor
covering.
IMPORTANT:
Minimum Installation Clearances
• When installed in alcove: Sides, Rear,
Top = 0" (0 cm)
• When installed in closet: Sides, Rear,
Top = 0" (0 cm), Front = 1" (2.54 cm)
• Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm
(7.6 cm) from top and bottom of door
Installation Instructions
34" (86.36 cm)
), located 3"
2
15

ROUGH-IN DIMENSIONS

FRONT
27" (68.58 cm)
SIDE
34" (86.36 cm)
*NOTE:
With Washer Legs: 40.5" (102.5 cm)
(0.75" adjustability)
With Pedestal: 53.75" (136.6 cm)
(0.75" adjustability)
Stacked: 82.75" (209.8 cm)
27" (68.58